1: Adjust the height of the glue stick (put the product to be glued, make the glue stick contact the product, and then adjust it down by 0.2-0.5mm).

2: Adjust the gap between the gluing stick and the gluing stick (if the contact exceeds 0.2-0.5mm, the gluing thickness can be adjusted according to the gap).

3: Adjust the height of the glue scraping stick (gap 0.00-0.2mm, gap size = glue thickness)

4: Inject glue (dip the glue stick into the glue)

5: Turn on the power supply, turn on the switch and adjust the appropriate speed (the glue stick is about 10% faster than the conveying linear speed)

6: Put in the product, try coating, visually check the gluing amount and coverage state of the product, and then adjust the glue stick up and down.

7: Whether the drying channel temperature adjustment (opening) is opened according to the dry and solid conditions of the products on site